Hello! Welcome to visit the official website of Changsha Xinao instrument and Meter Co., Ltd.


【Daily maintenance of centrifuge】

Release time:2018/8/29 16:43:55 Source:Xin Ao Instrument Co., Ltd. visits:

1. The power supply should be cut off before the centrifuge runs and the centrifuge brake should be loosened. The drum can be rotated manually to see if there is any brake biting.

2. check whether other parts are loose or abnormal.

3. Turn on the power supply to start clockwise (usually from static state to normal operation takes about 40-60 seconds);

4. normally, each device will be operated for about 3 hours after the plant has been run.

5. materials should be placed as evenly as possible.

6. must be specially operated, and the capacity must not exceed the quota.

7. strictly prohibit the overspeed operation of the machine, so as not to affect the service life of the machine.

8. after the machine is started, if there is any abnormal condition, it is necessary to stop the inspection. If necessary, it needs to be disassembled and washed.

9. centrifuge works at high speed, so it can not be used to touch the body and turn the drum to prevent accidents.

10. The number of filter cloth should be determined according to the size of the solid particles of the material to be separated, otherwise the separation effect will be affected.

11. in addition, filter cloth should be installed when the filter cloth is inserted into the drum sealing groove, so as to prevent the material running in.

12. in order to ensure the normal operation of centrifuges, the rotating parts should be refueling and maintenance once every 6 months.

13. at the same time to see whether the lubrication operation of the bearing, whether there is wear.

14. Whether the parts in the brake device are worn out or not, and whether there is oil leakage in the bearing cover, the parts in the brake device should be replaced seriously.

15. when the machine is finished, clean work should be done to keep the machine clean.

16. do not separate non - corrosion centrifuges from highly corrosive materials.

17. In addition, strictly in accordance with equipment requirements and regulations, non-explosion-proof centrifuge must not be used in flammable, explosive occasions.